square one cut

View Cart | Check Out

Measuring Your Square Spa Cover or Spa
with One Cut Corner

    It is best to measure your old cover if you have it available, otherwise please read the instructions carefully.

Should I measure just the spa (acrylic), or should I include the wood rim?

This is a personal preference, however most folks measure just the spa acrylic, lip to lip. (See figure below). In some cases you may want to measure to the wood rim, only because it may look better to you and it doesn't create a "rim" for leaves and other items to collect on. It does not help one way or another with energy efficiency.

Another thing to consider is the cover skirt/flap, you will want this to hang STRAIGHT DOWN. So, if the lip of the spa is at an angle, make sure you measure the cover long enough to achieve this. You don't want the skirt sticking out by measuring your cover too short. Also, measure the skirt (3" is standard)
long enough to cover the spa lip, or the spa cabinet rim. (See figure below)

It is always better to make the cover size a little bit bigger than your spa when measuring. If you make a mistake, and measure too small, the cover will not fit properly, will not sit flat and will not hold the heat in.

Enter Side B Here


Enter C Here


Top View

Enter Length A Here


Enter Width
D Here


Skirt Length:


Cover Type:

Color Preference:

Note: Tonneau Covers are only available in grey

Is Cover Larger than 8 Feet:

Cover Lifter:

Tie Downs:
Every new spa cover includes four (4) locking tie downs. Each tie down is approximately 9 1/2" long including the attached clip. To secure all 4 sides, one tie down will be attached near each corner. If you would like custom tie down placement, please email a diagram showing where you would like your tie downs attached. We can't guarantee the attached clips will be the same size, exact placement, or that tie downs will line up with your existing locks, so new locks and mounting hardware are included with your new cover.

   customer MUST email a diagram showing desired tie down placement.

Detached Adjustable Tie Down Straps:
Locking tie down straps that run across the top of your cover to help hold it securely in place. Tie Down Straps adjust from 6' to 12', and include a male clip on each end, 2 female locks and mounting hardware.

Shipping Insurance:


Additional Comments
or Instructions



[Home] [Covers] [Colors] [Measuring] [Cover Lifters] [Care] [Accessories] [Contact Us] [Covers In Stock]